These instructions are for the following throttle cable setups:
PHR Stainless Throttle Cable for Factory Twin Turbo Intake Manifold
PHR Stainless Throttle Cable for Factory Non Turbo Intake Manifold
PHR Stainless Throttle Cable for Hypertune Intake Manifold
PHR Stainless Throttle Cable for Greddy Intake Manifold
PHR Stainless Throttle Cable for Virtual Works Intake Manifold
Your Powerhouse Racing Throttle Cable will need a few parts from your existing throttle cable in your car whether you are just upgrading your factory cable or doing a twin turbo conversion. You can use parts from a non-turbo throttle cable or twin turbo throttle cable, the parts you will need will be the same. These parts are also on the factory throttle cable from the SC300.
Here are the parts you will need:
1. Steel Bracket with Pedal Stop
2. Rubber Insulator with two holes in it
3. Pedal Bushing w/ Retaining Clip
Here are the steps needed to remove these from your factory throttle cable and install them onto the PHR Throttle Cable
Step 1
Pry the steel bracket from the Rubber Insulator and remove it from the throttle cable
Step 2
